New Post Latest how to flash update Installing Rockchip drivers for flashing
Posted in
No comments
Wednesday, 21 January 2015 By Unknown
Installing Rockchip drivers for flashing!
Installing drivers for Rockchip based Tablets!
Please follow the instruction below to install the Rockchip drivers onto your computer for purposes of flashing your tablet with custom firmware etc. This is the Arnova 10G2 Method, please refer to your own tablet recovery mode.
1) Hold the volume up
2) Press the reset button for two seconds than release while still holding the volume buttom, a few seconds later the tablet will go into recovery mode, the screen goes black.
3) Connect your tablet to your Pc with the supplied cable.
You will now see this pop up on your computer.
Now go into device manager on your computer and look for the UNKNOWN DEVICE, right click and select update device software and you will be presented with this screen.
------------------------------------------------------------------------------------------------------------------------------
Now click browse my computer for driver software. Locate the firmware folder and go to the drivers folder and select the correct driver for your operating system. This will now load the Rockchip driver for your tablet. See below
Click the always trust software from box, and this will install the Rockchip drivers on your computer and you will see this come up when finished.
--------------------------------------------------------------------------------------------------------------------------------
You can now see the RK29 Device in device manager.
That is the driver installed and ready to go!
Installing firmware using the Rockchip RKAndroid Tool
Go into the firmware folder and start the RK29 update program.
You should now see the FOUND RKANDROID LOADER ROCK USB at the bottom of the program screen, this is good your device is connected. Click Erase IDB and you will notice that some writing will come up on the right, just wait for that to complete. Now click run and this will install the firmware on your tablet.
Be patient for this bit it can take up to 5 minutes, you will notice that your tablet will have some writing come up on it, this is the flashing process. Once this is done your tablet will reboot with the new firmware!
Installing drivers for Rockchip based Tablets!
Please follow the instruction below to install the Rockchip drivers onto your computer for purposes of flashing your tablet with custom firmware etc. This is the Arnova 10G2 Method, please refer to your own tablet recovery mode.
1) Hold the volume up
2) Press the reset button for two seconds than release while still holding the volume buttom, a few seconds later the tablet will go into recovery mode, the screen goes black.
3) Connect your tablet to your Pc with the supplied cable.
You will now see this pop up on your computer.
Now go into device manager on your computer and look for the UNKNOWN DEVICE, right click and select update device software and you will be presented with this screen.
------------------------------------------------------------------------------------------------------------------------------
Now click browse my computer for driver software. Locate the firmware folder and go to the drivers folder and select the correct driver for your operating system. This will now load the Rockchip driver for your tablet. See below
Click the always trust software from box, and this will install the Rockchip drivers on your computer and you will see this come up when finished.
--------------------------------------------------------------------------------------------------------------------------------
You can now see the RK29 Device in device manager.
That is the driver installed and ready to go!
Installing firmware using the Rockchip RKAndroid Tool
Go into the firmware folder and start the RK29 update program.
You should now see the FOUND RKANDROID LOADER ROCK USB at the bottom of the program screen, this is good your device is connected. Click Erase IDB and you will notice that some writing will come up on the right, just wait for that to complete. Now click run and this will install the firmware on your tablet.
Be patient for this bit it can take up to 5 minutes, you will notice that your tablet will have some writing come up on it, this is the flashing process. Once this is done your tablet will reboot with the new firmware!
Related posts
Share this post
0 comments: